01Introduction
Most batch failures start with an unchecked raw material. A wrong TiO2 grade or damp sand shows up only at the end.
Testing everything is not needed; focus on the materials that drive performance and cost.
02Why It Matters
- Prevents defective batches
- Gives you data to hold suppliers to
- Controls cost by catching substitution
03Tests & Reference Methods
| Test | Purpose | Reference |
|---|---|---|
| Binder emulsion | Solids, pH, viscosity | Oven and meters |
| Titanium dioxide | Grade, oil absorption, whiteness | Certificate and trial |
| Calcium carbonate | Fineness, whiteness, moisture | Sieve and oven |
| Cement | Fineness, setting, colour | Supplier data and trial |
| Sand | Moisture and grading | Oven and sieve set |
| Cellulose ether | Viscosity grade | Solution viscosity |
| Redispersible polymer powder | Ash, moisture | Oven and furnace |
| Solvents | Water content and purity | Certificate |
04How IPCS Supports Your Laboratory
- Material check list and limits
- Simple test methods
- Supplier qualification
Methods and limits depend on your product and applicable standard. We confirm them with you before the laboratory is commissioned.
05Frequently Asked Questions
Do I need to test every delivery?
Test key materials each lot and others by sampling.
Can I rely on supplier certificates?
As a base, with periodic own checks.
How do I check sand?
Moisture by oven, grading by sieve.
What about binders?
Solids, viscosity and pH.
What if a lot fails?
Quarantine and inform the supplier.
