Paint plant, machinery & formulation consultancy, India and worldwide

Paint Gloss Testing with Gloss Meter

How gloss is measured, which angle to use and how to keep results comparable.

01Introduction

In short: gloss is measured with a gloss meter at 20, 60 or 85 degrees. Use 60 degrees as the general angle, 20 degrees for high gloss and 85 degrees for matt finishes. Panels must be smooth, uniformly coated and fully dry. Gloss labels such as matt, satin or silk should be based on measured values.

Gloss defines the look customers pay for and the label on the can.

Gloss changes with film thickness, drying and substrate, so tests need consistent panels.

02Why It Matters

  • Confirms the finish level
  • Compares formulations
  • Detects flatting or dispersion problems

03How the Test or Routine Works

  1. Prepare panelSmooth glass or sealed card.
  2. Apply filmUniform thickness with applicator.
  3. Dry fullyFixed time.
  4. Calibrate meterStandard tile.
  5. Read several pointsAverage.
  6. RecordAngle and conditions.

04How IPCS Supports Your Laboratory

  • Gloss targets by finish
  • Test method and panel preparation
  • Reformulation advice

Methods and limits depend on your product and applicable standard. We confirm them with you before the laboratory is commissioned.

05Frequently Asked Questions

Which angle should I use?

60 degrees generally; 20 for high gloss; 85 for low gloss.

What is a matt value?

Low gloss at 60 or 85 degrees; set your own bands and state them.

Why do readings vary?

Film thickness, texture and cure.

How often calibrate?

Before each session using the standard tile.

Can I quote exact gloss?

Yes with test conditions.

Ask About Laboratory Setup

Tell us what you want to make. A paint technologist replies with next steps within one working day.

Your details are used only to reply to this enquiry. Direct line: +91 82104 79182.

Planning a paint or dry mix plant?Get Technical Consultation